4 installation steps – AirLive POE-FSH808AT User Manual
Page 8
Advertising
1. Introduction
AirLive POE-FSH808AT User’s Manual
3
1.4 Installation Steps
This section lists the installation procedures in steps. Each step’s instruction is thoroughly
explained in the subsequent sections of following chapter.
Step1. Connect your device's active PoE port to the switch's LAN port
Step2. Connect your PC to the switch.
Step3. Set your PC's IP address to 192.168.2.50.
Step4. Open your web browser and enter "192.168.2.1" to get into the switch's web
management.
Step5. Enter "admin" for username and "airlive" for password.
Step6. Go to "Port Management", and then select "PoE".
Step7. Turn on the port number where you connect the device.
Active PoE
Advertising