AirLive POE-FSH808PW - Manual (Page 12)

2. Installation of the Switch
AirLive POE-FSH808PW User’s Manual 7
 Reset:
The Reset button is to reset all the setting back to the factory default.
*Note: Be sure that you recorded the setting of your device, else all the setting will be
erased when pressing the “
Reset” button.
2.2.2 Rear Panel
The 3-pronged power plug is placed at the rear panel of the switch right side shown as
below.
2.3 Installation Site Preparation
You can mount POE-FSH808PW either on desktop or on a 19-inch rack. If you plan to
mount the switch on desktop, please choose a steady, level surface in a well-ventilated
area that is free from excessive dust. In any case, the installation site chosen for your
switch has to comply with the following requirements:
 The surface where you want to mount the switch must be able to sustain at least 1.5kg.
 Do not place heavy objects (more than 3kg) on top of the switch.
 The location must preferably be free from excessive dust, away from heat vent, hot-air
exhaust and direct sunlight.
 The switch should not be placed near large electric motors or other strong
electromagnetic sources. As a reference, the strength of the electromagnetic field on
site should not exceed the (RFC) standards for IEC 801-3, Level 2(3V/M) field strength.
 The air temperature in the location should be within a range of 0 to 65°C.