3 bandwidth control – AirLive POE-FSH808PW User Manual
Page 30
4. Web Management
AirLive POE-FSH808PW User’s Manual
25
Monitored packets:
i.
Disable: means this function is disabled.
ii.
RX: means copy the incoming packets of the selected source port to the selected
destination port.
iii.
TX: means copy the outgoing packets of the selected source port to the selected
destination port.
iv.
RX & TX: means the combination of Rx and Tx.
Source port: the traffic source that will be copied to the destination port.
Take the following configuration as an example.
i.
Source port: Port 1 ~ Port 4.
ii.
Destination Port: Port 5 ~Port 8.
iii.
Mirrored packet: Rx.
This means all packets received at port 1 ~port 4 will be copied to port 5, port 6, port 7 and
port 8.Care should be taken that the more source ports and destination ports is set, the
lower network throughput is available for normal traffic.
4.5.3 Bandwidth Control
This page allows the setting of the bandwidth for each port. The TX rate and Rx rate can be
filled with the number ranging from 1 to 255. This number should be multiplied by the
selected bandwidth resolution to get the actual bandwidth.