AirLive Traveler3G II - Manual (Page 92)

AirLive Traveler 3G II User’s Manual
88
Note: Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
1. Go to Start > My Computer > Properties.
2. Select the Hardware Tab.
3. Click Device Manager.
4. Double-
click on “Network Adapters”.
5. Right-click on Wireless Cardbus Adapter, or your specific network adapter.
6. Select Properties to ensure that all drivers are installed properly.
7. Look under Device Status to see if the device is working properly.
8. Click “OK”.
2: Why my wireless client can NOT access the Internet?
Note: Establish WiFi Connection. As long as you select either WEP or WPA-PSK
encryption, ensure encryption settings match your WiFi settings. Please refer to your WiFi
adapter documentation for additional information.
Ensure that the wireless client is associated and joined with the correct Access Point.
To check this connection, follow the steps below:
1. Right-click on the Local Area Connection icon in the taskbar.
2. Select View Available Wireless Networks in Wireless Configure. The Connect to
Wireless Network screen appears. Ensure you have selected the correct available
network.
Ensure the IP Address assigned to the wireless adapter is within the same subnet as the
Access Point and gateway. The Traveler 3G II has an IP Address of 192.168.1.1.
Wireless adapters must have an IP Address in the same range (e.g., 192.168.123.x).
Although the subnet mask must be the same for all the computers on the network, no two
devices may have the same IP Address. Therefore, each device must have a unique IP