AirLive WN-250R - Manual (Page 70)

2. System and Network Setup
61 AirLive WN-250R User’s Manual
associated to the router can access the Internet service through
the wireless network.
Note: In this mode, if you are informed by your wireless ISP that
the wireless settings of the access point is changed, please
configure the router in this page for match the settings.
staEnable: enable this function and the router can only allow to be
connected through wired Ethernet cable for WAN access service.
SSID (2): This is the name of wireless network. Input the SSID name that your
wirelesses ISP provide to you.
Channel Number (3): This is the radio frequency used to transmit and Receive the
wireless signal. The wireless devices in the same network should
follow the same setting. Select the channel designated by your
wireless ISP.
Site Survey (4): Click ‘Select Site Survey’ button, then a “Wireless Site Survey Table”
will pop up. It will list all available access points nearby. Select the
access point designated by your wireless ISP in the table and the
router will join wireless network through this access point.
Security Settings (5): If the access point enables wireless security, you have to follow the
same settings in order to access the access point. Click to set
security settings for this connection (Please go to section ‘2-7-3
Wireless Security’ for detailed instructions).