AirLive WN-300R - Manual (Page 93)

Static Routing Table
• If RIP is not used, an entry in the routing table is required for each LAN segment
on your Network, other than the segment to which this device is attached.
• The other Routers must also be configured. See Configuring Other Routers on
your LAN later in this chapter for further details and an example.
Figure 63: Routing Screen
Data - Routing Screen
RIP
RIP Direction Select the desired RIP Direction.
RIP Version Choose the RIP Version for the Server.
Static Routing
Static Routing
Table Entries This list shows all entries in the Routing Table.
• This area shows details of the selected item in the list.
• Change any the properties as required, then click the
"Edit" button to save the changes to the selected entry.
Buttons
Add Add a new entry to the Static Routing table, using the data
shown in the "Properties" area on screen. The entry selected
in the list is ignored, and has no effect.
Edit Update the current Static Routing Table entry, using the data
shown in the table area on screen.
Delete Delete the current Static Routing Table entry.
Save Save the RIP setting. This has no effect on the Static Routing
Table.
AirLive WN-300R User’s Manual 87