AirLive WP-201G V2 User Manual
Page 55
AirLive WP-201G v2 User’s Manual
47
Port Name is the name of the printer port. Each printer port has to be assigned a name. The client utility uses
this name to access the printer port.
Upgrade Firmware: You can use this “Upgrade Firmware” tool to update the newest firmware of the print
server. Click on the
button and select the correct firmware in your PC. After selecting the firmware file,
click the “Upgrade” button to finish the firmware update process. If you want to reset the Print Server to default
factory settings, please click Load Default.
Wireless Function: You can select “Enable” or “Disable” to manually enable or disable the wireless function.
If you manually enable wireless function, the print server’s wireless LAN will be always enabled and Ethernet
will be always disabled. If you manually disable the wireless function, the print server’s wireless LAN will be
always disabled and Ethernet will be always enabled. You can also select “Auto” to let the print server
automatically decide whether to enable or disable the wireless function. The print server can only work in
either Ethernet or wireless LAN mode. It cannot work in both Ethernet and wireless LAN mode at the same
time. When the print server starts up, it will auto-detect if the LAN port is connected to an active network by
Ethernet cable when starting up, the print server will run in Ethernet mode. If the print server is not connected
to an active network by Ethernet cable when starting up, the print server will run in wireless LAN mode. The
print server default is in “Auto” mode.
Domain Country: The wireless channels are different from country to country. Generally, the channels are
from 1 to 11 in USA and from 1 to 13 in Europe. The operating channel will be set to the print server before
importing. If you are in a different country, please make sure that you have set the available channels
according to your location.
7.13 Wireless Configuration
If you want to use the print server through wireless LAN, please set up the print server through Ethernet first
and make sure your wireless LAN setting is correct. After setting the wireless LAN, unplug the Ethernet cable
and restart the print server, then you can start to use the print server through wireless LAN. If the wireless
configuration does not work, please plug the Ethernet cable again, restart the print server and configure the
print server through Ethernet until the wireless LAN settings are correct.
The default settings of the print server wireless function are as follows:
‐ Mode:
Infrastructure
‐ SSID:
Default
‐ Channel:
11