APG DCR-WEB user manual - Manual (Page 8)

DCR-WEB Rev. A3, 10/08
8
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
R
E
L
A
Y
R
E
L
A
Y
2
-3
=
N
O
1
-2
=
N
C
Relay Jumper Settings
Default = NO
1
3 3
2
1
2
• Wiring
Step 1: Mount sensor so that transducer has a clear path to the target.
Step 2: To obtain access to the terminal strip, remove the front cover by
turning out the 4 screws. This will expose the terminal strip and 2 X 8 character
display.
Step 3: Wires can be pulled into the DCR-WEB through the strain reliefs on
the enclosure.
The screw terminal can be wired using solid or stranded wire between 16 - 20
AWG. Wires should be stripped, leaving a 0.4 in. bare wire.
Follow the legend on the circuit board when wiring. The DCR-WEB should
never be used without the earth ground terminal being connected.
Step 4: Perform an internal check to ensure that all wires are properly
connected and secured.