Installation instructions, Warning – Autoquip SR4 MANUAL TURNTABLE User Manual
Page 12
12
6.
Check the pit dimensions. Overall length and width should be a minimal two
inches longer and wider than the turntable platform.
7.
To ensure that the turntable is positioned exactly over the opening in the floor
before it is lowered, a position switch is mounted and wired to the turntable base
(see Figure 6).
8.
Lower the lift into the pit and check for proper combined height.
9.
Position and adjust the platform in the pit making sure there is proper clearance
(1” minimum around the edges from the platform to the pit angle).
10.
Make the permanent electrical connections and operate the lift through a few
cycles, ensuring that the lift will not lower if the turntable platform is not in the
proper position.
CLEAN UP
1.
Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
2.
Touch-up paint may be purchased from Autoquip for repair of damaged paint
surfaces.
WARNING!
All warning and information decals should be in place as outlined in the
“Label Identification” section. If decals are missing or damaged, they
should be replaced with new ones. Contact Autoquip for replacements.
INSTALLATION INSTRUCTIONS