Installation instructions, Caution, Warning – Autoquip SR4 MANUAL TURNTABLE User Manual
Page 9
9
FLOOR MOUNTING
1.
Make sure the installation area is clean before starting.
2.
Place the turntable base in the installation area. Set the turntable platform aside
for now.
CAUTION!
When moving the turntable assembly, do not attempt to pick it up by the
turntable platform; it is attached and could be damaged. Pick up the
turntable from under the base frame at a joint ONLY.
3.
The base plate of the turntable has pre-drilled holes for lagging the turntable
securely to the floor. Mark the holes, drill, and install with anchors. Verify that
the surface that the turntable will be mounted on is of sufficient strength to
support the loads.
4.
Install the turntable platform to the turntable base as shown in Figure 5.
WARNING!
The turntable base MUST be lagged securely to the floor or sufficient
structure before operating the turntable.
INSTALLATION INSTRUCTIONS