Operating instructions – Autoquip SR4 MANUAL TURNTABLE User Manual
Page 17
17
Familiarize yourself with this operator’s manual before operating this
equipment.
1.
Turntables have maximum capacities that vary depending on the model (see
“Specifications” section). Applying loads that exceed the rated capacity of the
turntable may result in excessive wear and damage to the turntable as well as
possible personal injury.
2.
Always place the load as close as possible to the center of the turntable platform.
Standard turntables are designed to operate optimally with the center of gravity
of the load within 10 inches of the center pin of the turntable.
3.
The standard turntable is not designed to withstand high-point loads (pallet jacks
or carts wheeled onto the platform, conveyed loads rolling onto the platform, etc.)
on the outside edge of the turntable platform. High-point loads will tip the
platform to one inch or more. If the application involves edge loading, please
contact the Autoquip Service Department to discuss possible solutions to prevent
excessive platform tipping.
WARNING!
The turntable base MUST be lagged securely to the floor or sufficient
structure, or attached to a lift platform (when applicable) before operating
the turntable.
WARNING!
Load the platform top as evenly as possible to prevent overloading.
WARNING!
NEVER stand, sit or ride on the turntable!
OPERATING INSTRUCTIONS