Autoquip SERIES 35 TILTERS - Manual (Page 11)

11
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to one side of the tilter.
This figure is a net capacity rating for a tilter furnished with the standard platform. The
relief valve of the pumping unit has been set to raise the weight, plus a small amount for
overload. Tilters should not be overloaded beyond the established capacity as
damage and/or personal injury may result.
UNBALANCED LOADING
The stabilization provided is basically for balanced loads. If special attachments extend
beyond the length and/or width dimensions of the platform, the end and/or side load
capacity is reduced. If the load is rolling onto the platform (in any but the fully-lowered
position) the end and/or side load capacity is also reduced.
Series 35
Model #
Capacity
(pounds)
Travel Lowered
Height
(Inches)
Standard
Platform
(Inches)
Base
Size
Raising/
Lowering
Time
(seconds)
Electric
Motor
(hp)
Shipping
Weight
(Pounds)
STE-30-25-4 2500 30 8 44 x 44 24 x 41 5 1.5 500
STE-45-25-4 2500 45 8 44 x 44 24 x 41 8 1.5 225
STE-30-25-5 2500 30 8 50 x 50 24 x 41 5 1.5 530
STE-45-25-5 2500 45 8 50 x 50 24 x 41 8 1.5 600
STE-30-40-4 4000 30 8 44 x 44 24 x 41 5 1.5 525
STE-45-40-4 4000 45 8 44 x 44 24 x 41 8 1.5 550
STE-30-40-5 4000 30 8 50 x 50 24 x 41 5 1.5 625
STE-45-40-5 4000 45 8 50 x 50 24 x 41 8 1.5 650
STE-30-60-4 6000 30 8 44 x 44 24 x 41 5 1.5 550
STE-45-60-4 6000 45 8 44 x 44 24 x 41 8 1.5 575
STE-30-60-5 6000 30 8 50 x 50 24 x 41 5 1.5 650
STE-45-60-5 6000 45 8 50 x 50 24 x 41 8 1.5 675
SPECIFICATIONS