Blocking instructions – Autoquip SERIES 35 TILTERS User Manual
Page 13
13
1. Remove all load from the platform. Never block the tilter when loaded, only when
empty.
2. Raise the platform sufficiently to insert both maintenance pins (see Figure 11).
3. Lower the platform completely to rest on the maintenance pins. Always hold the
“DOWN” switch a few seconds more until all pressure is gone and the platform is
supported entirely and safely on the maintenance pins.
4. Always shut off the main electrical switch, when blocked, to prevent someone from
turning it on.
WARNING
!
To avoid personal injury, NEVER go under the tilter platform
until the load is removed and the platform is securely blocked in
the open position to prevent accidental lowering of the tilter.
5.
To remove the maintenance pins, raise the platform by activating the “UP” button
to provide sufficient clearance to remove the pins.
BLOCKING INSTRUCTIONS