Autoquip SERIES 35 TILTERS - Manual (Page 17)

17
5. Raise and lower the tilter to make positioning adjustments and align the platform
in the pit with a proper clearance of _” minimum around the edges from the
platform to the pit angle.
DANGER !
Do not work under tilter without Maintenance Device! To avoid
personal injury, NEVER go under the platform until the load is
removed and the platform is securely blocked in the open
position. See "Blocking Instructions" section.
6. The base frame of the tilter has pre-drilled holes for lagging it securely to the
floor. Mark hoes, drill, and install with anchors. Tilters have minimum pull out
requirements of 2,000 lbs. for each anchor.
7. Make the permanent electrical connections and operate the tilter through a few
cycles.
CLEAN UP
1. Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
2. Touch-up paint is available from Autoquip for repair of damaged paint surfaces.
WARNING!
All DANGER, WARNING, and CAUTION labels and
informational decals and plates must be intact and in place on
the tilter. Contact an Autoquip representative if labels are
missing or damaged. See “DANGERS, WARNINGS, and
CAUTIONS” section of this manual.
INSTALLATION INSTRUCTIONS