BAND-IT UL4000-B Cordless Ultra-Lok Tool - Manual (Page 7)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P07986 Rev. F
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
www.BAND-IT-IDEX.com
Page 7 of 14
UL4000-B
UL4000-B220
Ultra-Lok

Tool
Troubleshooting
19
23
22
6
18
29
30
2 Places
4 Places 4 Places
4 Places
4 Places 28
6
20
2 Places
See page 6 for parts list
Trouble-Shooting
1. Lock slips down in buckle: Tighten blade mounting screws. If lock on clamp is still not adequate,
reduce tension on tool by setting torque setting on the Drill Dial to a lower number.
2. Drill clutch releases prematurely: Make sure Tool is fully seated on Drill (per page 4). If problem
persists, contact BAND-IT technical support.
Note: To mitigate Drill Clutch wear, do not over-use the Drill Clutch. When tensioning a clamp, let the
Drill Switch go as Tension Block nears its end of travel. Reverse drill and send Tension Block all the way
forward for a second pull on the band.
3. If tool does not cut off on initial setting:
Step 1: Pull trigger of tool after engaging cutter blade.
Step 2: Increase torque setting slightly, and repeat tensioning band and engaging of cutter blade.
Step 3: Repeat steps 1 and 2 until band cuts.
4
Tension Block
Assembly
Head Unit