BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool - Manual (Page 10)

Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
10
XIT6000-CA
3/8” Tie-Lok ® Tool
Setup &
Assembly
Instructions
Handle adjustment:
• Using 1/4” hex key (supplied), adjust
the Support Arm/Handle to ergonomically
match the operators hand.
• Be sure not to adjust the Handle too far
outward (beyond interlocking legs) or the
handle will not function properly or
provide support to the operator.
Hanger Support Instructions:
1. A steel hanger can be utilized for
supporting the tool with a
counterbalance. Full weight of tool
should not be supported by a single
hole.
2. A hanger can be installed (as
shown) into one of the three
supplied threaded holes. To
prevent internal damage, only 1/8”
of the hanger threads should be
threaded into the hole.
3. Secure the hanger against the tool
body with a lock nut as shown. This
will prevent movement of the
hanger during tool operation.
4. Use a light application of Loctite,
Red, high-strength, on threads of
hanger prior to installation.
Hanger Mount