BLACKHAWK! LEVEL 2 SERPA LIGHT BEARING FOR XIPHOS NT - Manual (Page 12)

2.3 Level 2 SERPA ® Auto Lock ™ Test
After properly adjusting the level 1 passive retention, test the SERPA ® Auto Lock ™ several times for proper
functioning. Confirm the following:
1. When holstering, the SERPA ® Auto Lock ™ should engage the trigger guard with an audible “click.”
2. When seated inside the holster, the firearm should not rattle or move excessively.
3. When your firearm is properly seated in the holster and constant upward force is applied to the firearm, you
should not be able to activate the SERPA ® finger tray. (This is an intended feature designed to immobilize
your weapon if someone is attempting to disarm you.)
4. When the SERPA ® finger tray is pressed, the SERPA Auto Lock ™ should not interfere with any part of the
firearm as it is removed from the holster.
2.4 Level 3 Pivot Guard Test (for Level 3 Duty and Light Bearing Holsters only)
1. With your firearm properly seated in the holster, press and hold the Pivot Guard thumb release with your
firing hand thumb.
2. While holding the Pivot Guard thumb release down, roll your index and middle fingers over the top of the
Pivot Guard and pull it to the rear over the slide of the firearm.
12