BLACKHAWK! LEVEL 2 SERPA LIGHT BEARING FOR XIPHOS NT - Manual (Page 18)

When holstering:
• Always keep your firearm pointed in a safe direction.
• Make sure the holster is free from any kind of obstructions that could engage the trigger.
• Always look at your holster when holstering until you have gained proficiency. Civilians should never
attempt to holster a loaded firearm without looking at the holster unless proficient in this technique and
properly trained by a qualified instructor.
• Never attempt to holster a firearm with your finger on the trigger or inside the trigger guard.
• Make sure the trigger, slide and hammer do not catch on any part of the holster.
• Place firearm straight into the holster until the SERPA ® Auto Lock ™ catches the trigger guard. You will hear
an audible “click” when the SERPA Auto Lock feature has been properly engaged.
• If you feel any resistance or have trouble properly seating the firearm, stop immediately and determine the
cause of the problem.
• For Level 3 holsters, engage the Pivot Guard following the instructions in Section 2.4 above.
WARNING!: If misused, certain unavoidable design features of some holsters can engage your firearm’s
trigger and cause an accidental discharge. Do not attempt to force your firearm at unnatural angles
against the outside of your holster. Place your firearm directly into the holster, pay attention to what you
are doing and practice holstering for proficiency before using under stress.
CAUTION!: Do not use SERPA ® Light Bearing Holsters without the Xiphos light attached to the firearm
as this will not properly secure the firearm. A firearm without a light can be placed into a Light Bearing
18