BLACKHAWK! LEVEL 2 SERPA LIGHT BEARING FOR XIPHOS NT - Manual (Page 8)

2. FIT AND ADJUSTMENT INSTRUCTIONS
WARNING!: Do not attempt to place a loaded firearm into your SERPA ® holster without carefully
following these instructions with an UNLOADED firearm.
2.1 Proper Firearm and Holster Pairing
Before you begin, look at the back of the holster body and confirm that you have the right size and model
holster designed to fit your firearm. This holster is only compatible with the firearms listed on the back of the
holster. If in doubt, contact us at 1-800-694-5263 or [email protected].
WARNING!: Do not use this holster with an incompatible, improperly maintained or abused firearm.
Failing to follow this precaution could cause an unintended discharge and/or defeat retention properties
and result in property damage and/or serious injury or death.
2.2 Level 1 “Passive Retention” Adjustment
The first level of retention on your SERPA ® holster is a result of friction from the holster body on the firearm’s
trigger guard (for Level 2 and 3 Duty Holsters) or against the firearm’s frame and light (for Light Bearing
Holsters). This friction is created by the detent that holds the trigger guard on the Level 3 Duty Holster and is
more active than the friction on the Level 3 Light Bearing Holster. Retention can be adjusted by tightening or
loosening the passive retention screw as follows:
8