Blue Sea Systems 7717 ML-RBS Remote Battery Switch with Manual Control Auto-Release - 24V - Manual

ML-RBS Operation ML-RBS Relay State Remote Control Switch LED
To manually disconnect battery
bank from load, or isolate battery
banks that are connected, rotate
manual override knob to the right.
Manual Override
LOCKED-OFF (open)
LED double blinking
ON-OFF
To manually connect battery bank
to load, or combine battery banks
that are connected, rotate manual
override knob to the left then push
down until latched.
Manual Override
ON (closed)
LED double blinking
ON-OFF
OFF
To restore remote switching,
manually set the RBS in the
“Remote Enabled OFF (open)”
position and push remote
switch “OFF”.
Remote Enabled OFF (open)
LED OFF
Remote Switch Operation ML-RBS Relay State Remote Control Switch LED
ON
To connect battery bank to load,
or combine battery banks,
press remote switch “ON”.
Remote Enabled ON (closed)
ON
OFF
To disconnect battery bank
from load, or isolate battery banks
that are connected, press remote
switch “OFF”.
Remote Enabled OFF (open)
OFF
The ML-Series Remote Battery Switch (ML-RBS) provides high-current carrying and switching under load.
The ML-RBS should be installed close to the battery to minimize voltage drop to the ML-RBS.
Install a single pole double throw (SPDT) or single pole single throw (SPST) control switch in a convenient
location near other electrical controls or companionway to allow quick access in the event of an emergency
(see Illustration on reverse).*
* Although a SPST switch may be used if desired, use of a SPDT switch improves immunity to inadvertent
switching if the switch terminals become damp.
.
ML- RBS
Remote Battery Switches
PN 7713 / PN 7713B / PN 7713100B
PN 7717 / PN 7717B / PN 7717100B
980018140 Rev.001
• Magnetic Latch (ML) - draws very low current continuous and draws
moderate current for a very short time when changing state
• Silver alloy contacts provide high reliability for switching live loads
• Manual override provides LOCK OFF capability for servicing and ON/OFF control with or without power
• LED output to remotely indicate switch state
• Tin-plated copper studs for maximum conductivity and corrosion resistance
• Label recesses for circuit identification
• PNs 7713 and 7717 include a Remote Control Switch PN 2155
Specifications 12V DC 24V DC
Cranking Rating See table below See table below
Intermittent Rating See table below See table below
Continuous Rating See table below See table below
ML-Coil Function Auto releasing Auto releasing
Operating Current: Continuous <13mA @ 25°C nominal voltage <13mA @ 25°C nominal voltage
Changing Stage (20 ms) <7A @ 25°C nominal voltage <4A @ 25°C nominal voltage
Contact Circuit Voltage 16V DC Max. 32V DC Max.
Live Current Switching 300A @ 12V DC—10,000 Cycles 150A @ 24V DC—10,000 Cycles‡
Mechanical Endurance 100,000 Cycles 100,000 Cycles
Control Circuit Voltage 9–16V DC 18–32V DC
Terminal Stud Size 3/8"-16 3/8"-16
Maximum Terminal Stud Torque 140 in-lb (15.8 N•m) 140 in-lb (15.8 N•m)
Ring Terminal Size 3/8" (M10) 3/8" (M10)
Terminal Ring Diameter Clearance 1.18" (30 mm) 1.18" (30 mm)
‡ Predicted performance
Remote Switch PN 2155
Action SPDT, ON-ON
Seals Internal & External Gasket Panel Seal
Mounting Hole 0.83"x 1.45" (21.08 mm x 36.83 mm)
LED Rating 100,000 hours half-life
Harness Connector: (select models) Deutsch DTM Series DTM 06-6S
Mating Part Requirements See LADD Industries www.laddinc.com
Receptacle Shell DTM-04-6P
Wedgelock WM-6P
Terminal Pins 1060-20-0122
Sealing Plugs 0413-204-2005
Hand Crimp Tooling DTT-20-0
Regulatory Meets ISO 8846 and SAE J1171 external ignition protection requirements, CE marked, Rated IP66
Marine Electrical Products
PN Termination Control Circuit
Remote Control
Switch Included
7713 Tinned Wires 12V DC SPDT, ON-ON
7713B Tinned Wires 12V DC -
7713100B Deutsch Connector 12V DC -
7717 Tinned Wires 24V DC SPDT, ON-ON
7717B Tinned Wires 24V DC -
7717100B Deutsch Connector 24V DC -
Overview of Application
Wire Size (AWG) Metric (mm²) Cranking 10 sec. Cranking 1 min. Intermittent 5 min. Continuous (UL 1107)
2/0 70 2,000A 750A 400A 225A
4/0 120 2,200A 750A 400A 300A
2x (4/0) 2x (120) 2,500A 1,100A 700A 500A
Blue Sea Systems Inc. p 360.738.8230
425 Sequoia Drive f 360.734.4195
Bellingham, WA 98226 USA [email protected]
www.bluesea.com
ON
OFF
Remote Operation
Manual Override Operation
OFF