COATS ProGuard Leverless Plus Tire Changer - Manual (Page 32)

Operation Manual - COATS PRO GUARD PLUS - 32
Supplied in the box
21.1_Optional Accessories
Clamping adaptor for rims without center hole (P/N# 89231514)
Fit the fl ange plate on the spindle chuck making
sure to match the assembling holes, securing it
with the 2 knobs supplied. Unscrew the securing
nuts.
Take the gauge supplied with the kit and measu-
re the center distance of 2 holes, then lock this
measurement on the gauge.
This clamping adaptor can be used on all wheels with any number of lug holes.
Position the pins based on the number of lug holes
in the rim, inserting the anti-rotation pin in the slot
and the securing screw in the threaded hole with
the number desired.
Note: The pin with the yellow screw must never
be removed.
Remove the rubber coated wide fl ange plate, then position the horse shoe
bracket on the spindle chuck, and secure it by tightening the screws.
NOTE: before using the following optional accessories (P/N#89231514, 89231512 and 89231513) remove the
wide, rubber coated table top as follow:
-Loosen anti-rotation pin pivot arm locking screw
-Move anti-rotation pin pivot arm aside, to access retaining screw for rubber coated table top.
-Loosen all rubber coated table top retaining screws and remove the table top
-Assemble the horse shoe bracket (always provided in each of the below mentioned accessory kits) on the smaller
table top, by tightening the 3 retaining screws.
1
2
3
4 5
4
21.0_STANDARD ACCESSORIES