COATS ProGuard Leverless Plus Tire Changer - Manual (Page 33)

Operation Manual - COATS PRO GUARD PLUS - 33
Turn the pins of the fl ange so that the center di-
stance matches the measurement made earlier
on the rim.
Tighten the securing screws of the pins.
Insert the wheel, matching up the clamping holes
with the threaded pins, position and tighten the
wheel securing nuts.
LT TRUCK CONE KIT (P/N# 89231512)
for clamping rims with center hole larger than Ø 4,8”-7,5” (120-190 mm).
Position the fl ange plate to the spindle chuck, making sure to match the
assembling holes, and secure it with the 2 knobs supplied.
Insert the wheel, matching-up the anti-rotation pin with a lug hole, position
and secure by tightening the clamping shaft over the cone.
Remove the rubber coated wide fl ange plate, then position the horse shoe
bracket on the spindle chuck, and secure it by tightening the screws.