Dascom 7010 Programmers Manual DMX - Manual (Page 121)

1-119
3.3 Storage and Readout Commands
Two commands are available for storage and readout.
1 System level commands (occasional execution commands starting
with 02H)
Graphic image writing commands for on-board RAM or on-board Flash
RAM or IC card.
I (A/B/C) faa..a
2 Label format commands (occasional execution commands without
control codes)
Graphic data reading commands for on-board RAM or on-board Flash
RAM or IC card
1Yaa000aa..a
Commands for reading and writing printing data (such as ruled lines and
character strings) in the on-board RAM or IC card
s(A/B/C) aa..a
raa..a
The user gives the required name to the data to be stored by using these
commands and the data is read out with this name.