Dascom T5040 User Guide - Manual (Page 32)

Control panel User Guide
24
USER1 and USER2 indicators The USER1 and USER2 LEDs are normally under the control of the
application. They are available to indicate to the user that the appro-
priate interface is active. Normally in Olivetti, IBM or Epson (Au-
to)emulations, with dual host connections they will indicate that a job
is available for the interface associated with the USER. In Epson Emu-
lation (Manual mode) they are lit under the control of the printer to in-
dicate the availability of a job for process: the job can be released by
inserting paper and pressing the associated key.
However please be aware that some applications may uses the LEDs
and keys in an entirely different way defined by the host software and
outside the definitions contained in this document.
The USER1 or USER2 indicator blinks:
` USER1 (interface 1) or USER2 (interface 2) receives data.
The USER1 or USER2 indicator lights:
` USER1 (interface 1) or USER2 (interface 2) processes data.
SETUP
PAPER
STOP
/EJECT
USER1 USER2
SETUP
PAPER
STOP
/EJECT
USER1 USER2