ERICO TDS-MOVTEC Surge Diverters - Manual (Page 25)

D I N L I N E I N S T A L L A T I O N I N S T R U C T I O N S
PAGE 25
INSTALLATION PROCEDURE FOR MPM
1. Remove the cover from the MPM.
2. Select the MPM mounting position to ensure
optimum electrical connection method (refer
Section 7) and in accordance with all given
instructions.
3. Position and mark the mounting position of
the MPM on the wall.
4. Depending on the mounting surface, prepare
suitable anchoring holes for the marked
position.
5. Snap the mounting spacers, supplied, into
the rear of the back of the MPM as shown
in Figure 1. (see inside back cover P31)
6. Mount the unit to the wall. To ensure the
IP33 rating is preserved, the MPM should
be mounted to the wall using the spacers
provided and one of the fixing methods as
shown in Figure 1. (see inside back cover P31)
7. Prepare the appropriate cable glands. It is
recommended that a nylon cable gland
(typically rated at IP66) be used.
8. Install wiring, taking care to support cabling
directly connecting to the MPM unit, and
tighten all terminals.
9. Check that the MPM is installed in accord-
ance with all instructions, and relevant
electrical safety codes.
10.Replace MPM cover, then apply power.
11.Correct operation of the MPM unit is estab-
lished by checking that all 5 LED’s on each
MOVTEC bar graph are lit, and that power
is correctly being supplied to the load(s).
INSTALLATION ARRANGEMENT FOR
AUSTRALIAN MEN SYSTEMS
Under Australian Standards classification,
MPMs are considered a piece of equipment to