ETC Source Four CE HID PARNel - Manual (Page 8)

English
8 Source Four HID PARNel CE
Positioning the wave/stippled lens (front)
• There are seven “notches” cut into the stippled side of the lens. Position the lens so that the cluster of three
notches is on top. The center notch of the cluster coincides with the spring clip on the lens retaining ring. (
Figure
6 )
• The bottom of the lens has a cluster of four notches. Place the two center notches behind the tabs at the bottom
of the lens rotating ring. (
Figure 5
)
Cleaning the reflector
1.
Unplug the fixture before attempting to clean the reflector.
2. Remove the lamp before attempting to clean the reflector.
3.
Remove the lenses so you can access the reflector from the front of the fixture.
4.
Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton cloth. If this is sufficient to
remove dust, go to step 7. Otherwise, continue to step 5.
5. Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and gently wipe the reflector.
6.
Remove any soapy water residue with a clean, soft, lint-free cotton cloth dampened with water.
7.
Reinstall the lenses before using the fixture.
C A U T I O N : Do not use glass or window cleaners on the reflector. Chemicals in the cleaners
will harm the reflective coating. Do not use paper towels or harsh materials to wipe
the reflector. These materials can scratch the surface of the reflector.
Housing assembly instructions
If you take apart the Source Four HID PARNel CE for any reason, please use the following steps for reassembly.
Improper reassembly will result in void of warranty and loss of performance.(See parts list on page 10)
Tools required: Phillips screwdriver.
1.
Install the reflector mount silicon pads (11) and lens pad (15) in the left barrel (7 or 8).
2.
With the wave side of the lens facing toward the front of the fixture, install the wave/clear lens (21) into the rear
lens track.
3.
Assembly items 16, 17, 18, and 19 (Focus knob assembly). Rotate the focus knob full spot position. The arrow
on the focus knob will point approximately to the 11 O’clock position.
4.
Place the focus knob assembly into the left barrel.
5.
Install the lens stop (14) and the rotator spring clip (12) into the lens rotator (12 or 13).
6.
Install the lens rotator into the left barrel.
7.
Install the rotator pressure clip (9) into the left barrel with screw (23).
8.
Install the gel retainer clip (1) and the spring (22) into the right barrel (5 or 6).
9.
Attach the right barrel to the left barrel using screws (3) in three places.
10. Check that the gel clip retainer (1) moves easily into position.
11.
Check for smooth rotation of the lens rotator (12 or 13).
12. With the wave side facing inward, install the wave/stippled lens (20) into the lens rotator.
Figure 6
Top center notch
Bottom two
center notches