Feiss WB1717 - Manual

1
Installation Instructions for
Lismore 1 and 3 Light Wall
1.0
V 43003-W 1717 S B
V 43003, W 1717_ S B
Secure the mounting plate to the electrical box with the two provided mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Install the candle tube by slipping it through the socket.
Install the shade by placing it over the candle tube.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information. Repeat steps 6-8 for
remaining sockets.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
1
1
5
6
5
Wall
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
MOUNTING
PLATE SCREW
SHADE
7
CANDLE TUBE
FIXTURE SCREW
ALLEN WRENCH
6
7
8
8