Flint & Walling NightBright Lighting System - Manual (Page 3)

3
95 North Oak Street • Kendallville, IN 46755
Copyright 2009. All rights reserved.
Operating Instructions and Parts Manual
INSTALLATION CHECK LIST

Read installation instructions and
warnings.

Post appropriate warning signs.
 Install NightBright lighting system
to float.
 Check insulation resistance to
ground.
 Connect NightBright lighting system
to control center.

Power up unit.

Test operation of GFI by pressing the
“Test” Button.

Set timer.

File instructions for future reference.
!
DO NOT handle pump or
lights with wet hands or
when standing in water as fatal
electrical shock could occur.
Disconnect main power supply before
handling system for any reason.
Troubleshooting Chart
Symptom Possible Cause(s) Corrective Action
Lights dim
or won't
light 1. Circuit breaker tripped
2. Low Voltage
1. Reset circuit breaker.
2. Verify voltage.
3. GFI Tripped
4. Excessive Cable Length
5. Timer/clock not set
6. Lights out of position
3. Reset GFI.
4. Verify acceptable maximum cable length.
5. Set clock to local time and timers for desired cycle. See Section on Setting Timers.
6. Aim lights to provide desired illumination.
GFI Trips 1. Electrical storm can trip GFI 1. Reset GFI.
2. Short in system
3. Defective power cable
2. Disconnect power and check cord for damage. If cord is damaged contact Customer
Service Help Line at 1-800-742-5044.
3. Disconnect power and check cord for damage. If cord is damaged contact Customer
Service Help Line at 1-800-742-5044.
Figure 1 - Installation
IL0827
4
2 3
1
5
3
6