7/8 in. break-away swivel – General Machine Products 7/8" Break-Away Swivel User Manual

Page 2

Advertising
background image

7/8 in. Break-Away Swivel







IMPORTANT NOTICE

Users are cautioned to ensure appropriate safeguards
exist especially during aerial cable placing. Should the
swivel break there must be sufficient support to pre-
vent the cable from reversing direction and creating
slack in an uncontrolled and potentially hazardous
manner. This is critically important when crossing
rights-of-way such as roadways, waterways or power
lines. Refer to your employer's work practices or con-
sult the factory for detailed information pertaining to
this most important safety procedure.

All personnel should stand clear of the pulling line

when using any break -away swivel, in the event that

excessive pulling resistance causes the swivel to break

apart and possibly exit the duct at great speed.

Notes:

1. Breaking tolerance ±5%

2. Warning!! Do not over tighten the tension bolt, be-

cause premature fracture may occur. Tighten the

bolt lightly until it bottoms (not using excessive

force). Then unscrew ½ turn to achieve proper bear-

ing clearance and swivel action.

3. See other side for disassembly procedure.

Aluminum 7/8 in. (22.2mm) Diameter
Break-Away Swivel

Break Point

Part Number

lbs.

kgs Color Code

Swivel

Repl Bolt

340

154

White

53700

30332

450

204 Orange

53701

34786

500

277

Violet

53706

34787

600

272 Yellow

53702

34341

800

364

Blue

53703

34342

1000 454

Green

53704

34343

1200 544

Red

53705

34344

P/N 15380 Replacement Thrust Washer Kit

General Machine Products Co., Inc.
3111 Old Lincoln Highway Trevose, PA 19053
TEL: 215-357-5500 FAX: 215-357-6216
E-Mail: [email protected]
http://www.GMPtools.com

GMP reserves the right, without notice, to make changes in equipment design

or components as progress in engineering or manufacturing methods may

warrant. All information contained herein is subject to such change.

P/N 24590 AK 060513

!

Swivel Body

Housing

(2) “O” Ring
P/N 17534

#6-32 Set Screw
P/N 17530

(2) Shoulder Screw
P/N 25300

Tension Bolt
See Chart

Thrust Washer Kit
P/N 15380

Stationary Body

Advertising