GeoDesy GD-Geo20-TP - Manual (Page 16)

16
Services
WNMS
– set WNMS server/collector URL allowing remote device configuration and monitoring.
System Alerts
– set alerts which can be sent via SNMP Traps or/and SMTP notifications. SNMP
– SNMP service settings allowing remote device monitoring.
Clock/NTP
– set device date manually or enable and configure NTP service.
SSH
– control SSH connection.
HTTP
– control HTTP connection.
System
Administration
– change password, reboot, restore factory default settings, backup/restore
configuration, troubleshooting file support.
Log
– view device log, set system log forwarding settings.
LED
– control operation of LEDs.
Firmware upgrade
– upgrade device firmware.
Tools
Antenna alignment
– measure received signal quality of the wireless link to align antenna in the
best direction.
Site Survey
– information about other wireless networks in the local area.
Delayed reboot
– setup delayed reboot for APC unit.
Ping
– perform ping command.
Traceroute
– perform graphical traceroute command.
Spectrum analyzer
– check the signal strength on available channels.
6.2 Appling and Saving Configuration Changes
There are three general buttons located on the right top corner of the W EB GUI allowing managing
device configuration:
Apply
– if pressed new configuration settings are applied instantly. It will take few seconds and
the device will be running with new settings. It should be noted that pressing Apply button
settings are not written to the permanent memory. Therefore, if the device is rebooted it will
start with old configuration settings.
Discard
– if pressed parameter changes are discarded. It should be noted that if Apply or
Save&Apply is pressed it is not possible to discard changes.
Save&Apply
– if pressed new configuration settings are applied instantly and written to the
permanent memory.
It is not required to press Apply or Save&Apply in every Web GUI tab. The deviceremembers all
changes made in every tab and after action button is used, all changes will be applied.