GeoDesy GD-Geo20-TP - Manual (Page 25)

25
LAN DHCP Settings
DHCP mode
– choose disabled to disable DHCP on LAN interface.
DHCP mode
– choose relay to enable DHCP relay. The DHCP relay forwards DHCP messages
between subnets with different sublayer broadcast domains.
DHCP mode
– choose server to enable DHCP server on LAN interface.
IP address from
– specify the starting IP address of the DHCP address pool.
IP address to
– specify the ending IP address of DHCP address pool.
Subnet mask
– specify the subnet mask.
Default gateway
– specify DHCP gateway IP address.
Lease time
– specify the expiration time in seconds for the IP address assigned by the DHCP server.
DNS server
– specify the DNS server IP address.
7.2.4 Wireless
The Wireless tab is divided in three sections: Basic, Security and Advanced configuration sections.
The Basic section contains all parameters that required to configure in order have working wireless
link. Security section is used to select authentication and encryption settings. Advanced section
contains parameters allowing optimizing the link capacity.
Before changing radio settings manually verify that your settings will comply with local
government regulations. At all times, it is the responsibility of the end-user to ensure that the
installation complies with local radio regulations.
The APC device can operate in four wireless modes: Access Point, Station, Station WDS, iPoll
Access Point and iPoll Station.