GeoDesy GD-Geo20-TP - Manual (Page 47)

47
Forward backup
– select to enable remote syslog logging backup.
Backup server
– specify the backup host IP address or hostname where syslog messages will be
send to.
Backup port
– specify the port to which syslog messages will be forwarded [0-65535]. Default: 514.
7.4.3 LED Control
The APC is equipped with 6 LEDs: power, LAN and 4 RSSI LEDs that indicates the signal strength of
current connection. The signal level is classified into 4 levels, thus corresponding 4 LEDs switches on
as soon as indicated threshold is reached.
Enable
– select to enable LEDs on the device. If this option is not selected, then no LED activity will
be visible on the device.
RSSI thresholds
– specify the RSSI threshold at which corresponding LED will switch on.
The Signal LEDs are working only when the connection is established. Therefore, please make
sure all wireless settings are correct and the connection is established.
LAN LED
– select to enable LAN LED. The red LED will be blinking on LAN activity, off – no LAN
connection.
Power LED
– select to enable Power LED. The steady red LED when power is on, off – no power.
7.4.4 Firmware Upgrade
To update your device firmware use the System | Firmware upgrade menu. Press Upload
firmware, select the firmware file and click the Upload button:
Current version
– displays version of the current firmware.
Upload firmware
– click the button to select the new firmware image for uploading it to the device.
The device system firmware upgrade is compatible with all configuration settings. When the device is
upgraded with a newer version or the same version builds, all the system‟s configuration will be
preserved after the upgrade.
The new firmware image is
uploaded to the controller‟s temporary memory. It is necessary to save the