Bose LIFESTYLE VS-2 - Manual (Page 21)

B
AS
IC
S
YSTEM
C
O
N
NE
CT
IO
N
S
21
Italiano Svenska Deutsch Nederlands English Français Español
B ASIC S YSTEM C ONNECTIONS
9 Connect the system to power
To complete this step, you need the two identical AC power cords, one for the Acoustimass ®
module and the other for the power supply.
To connect power to the Acoustimass module:
On the connector panel of the Acoustimass module, plug the appropriate end of one
AC power cord into the AC power jack (Figure 13). Insert the other end of the power cord into
an AC (mains) outlet.
Figure 13
Power connection for
the Acoustimass module
Note: Bose recommends using a high-quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system and the resulting
damage may not be covered by the limited warranty. A quality suppressor can eliminate the vast
majority of failures attributed to surges and may be purchased at electronics stores.
To connect power to the power supply:
Plug the appropriate end of the AC power cord into power supply (Figure 13). Insert the other
end of the power cord into an AC (mains) outlet.
Figure 14
Power connection for the
media center power supply
If you have a dual-voltage power supply:
Before connecting power to the media center power supply, MAKE SURE the voltage selec-
tion switch on the bottom of the media center power supply matches the local power rating
(Figure 14). Check with local electrical authorities if you are not sure of the appropriate power
rating.
AC (mains)
outlet
AC power jack
AC power cord
Acoustimass module
connection panel
AC Power cord
Voltage selection switch location
(dual-voltage units only)
Power supply
AC (mains)
outlet
VS-2
To the
media center