INFICON RS-3000 Power Supply Controller - Manual (Page 15)

RS-3000 Power Supply Controller
instruments
2 mA for +12 VDC (use Sycon approved power supply only)
3.6.4 Beeper:
Audible (when enabled) in the 80-90 decibel range @ ~2.5 KHz
3.6.5 Case:
Aluminum with a grounding stud which is common to all connector shields.
Shield/case ground is interconnected to RS-3000 digital ground within the product
with a 1k
Ω resistor.
3.6.6 Hand controller/pendant:
Has a 6 ft. coiled cord. Has an RJ-11 connector at one end and at the other end, a
module having 3 keys for remote useage of front panel keys: INCrement(
↑),
DECrement ( ↓) and STOP. This assembly is supplied by Sycon Instruments.
Connects to RJ-11 connector on the front panel.
3.6.7 Communications cable (optional):
A six ft. coiled cord terminated with an RJ-11 at one end (mates with RS-3000 back
panel connector [RJ-11]) and a 9 pin female D-SUB at the other (RS232/485 port).
This assembly is supplied by Sycon Instruments. Used to interconnect the RS-3000
control unit with an RS232/485 port such as, what may be found on a PC. Using
communication software on the PC, the RS-3000 can be controlled as if by front
panel controls and interrogated as if observing the displays and LEDS.
3.6.8 RS-3000/T3000 Interconnect cable:
A 3 ft. or 6 ft. cable assembly, wired straight-through (that is, pin 1 to pin 1, pin 2 to
pin 2, etc.) terminated at the RS-3000 side with a 15 pin female D-sub and with a 15
pin male D-Sub connector at the T3000 side. This assembly is supplied by Sycon
Instruments. It is used to interconnect the T3000 power supply and the RS-3000
control unit (T3000 control connector).
3.6.9 RS-3000/STC-2002 Interconnect cable:
A 6 ft. cable assembly terminated at the RS-3000 side with 15 pin male D-SUB
connector and with a 15 pin female D-SUB connector on the T3000 side. It is
interconnected from the RS-3000 external control connector to the STC-
2000A/STC2002 control outputs connector.
Specifics Page 3 - 4 Section 3