JUMO 707060 Wtrans B - Programmable Head Transmitter with Radio Transmission Operating Manual - Manual (Page 20)

5 Installation
20
5.2 Installing the antenna-battery case
Proceed as follows to install the antenna-battery case:
Step Activity
1 Guide the voltage supply socket (B) and SMB antenna socket (C) of the antenna-
battery case (A) through the opening (G) of the connection head (H).
2 Push seal (D) into the opening (G).
3 Screw the thread (E) into the opening (G). Turn the antenna-battery case until it
makes contact with the seal (D). To ensure impermeability, continue turning for at
least 1/2 to max. 1 1/2 revolutions.
For an optimum transmission performance, the antenna-battery case should be posi-
tioned vertically (to the top) independent of the connection head position. Ensure
that the cables also turn when the sockets (B) and (C) are turned while installing the
antenna-battery case. Avoid twisting of the cables.
4 Tighten the locknut (F) and secure the antenna-battery case against loosening.
(H)
(B) (C)
(G)
(D) (F)
(A)
(E)