JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual - Manual (Page 35)

35
7 Setup program
7.1 General information about the setup program
The setup program serves to configure probes and receivers by means of a PC. The configu-
ration data can be archived on data carriers and printed.
Configurable parameters are:
•
Probe ID
• Transmission interval
• Transmission frequency (with 915 MHz only)
The factory settings are:
•
Probe ID consecutively
• Transmission interval
• Transmission frequency 868.4 MHz (Europe) or
915.4 MHz (America, Australia, Canada, New Zealand);
ten frequencies for transmitter and receiver can be set in the 915 MHz frequency band
The setup program can be used to overwrite changed parameters with the factory settings at
any time.
The connection between probe and PC is established via a PC interface (USB/TTL or TTL/
RS232 converter).
Figure 12: Setup program of the probe