Klein Tools MM2000 - Manual (Page 4)

1
6
3
FUNCTION INSTRUCTIONS
Duty
º F º C
m
Low Z
DTEK
4
5
1
2
D. Auto Power-Off (Apo)
• Device will power off after 30 minutes non-use.
• Turn the dial or press a button to wake.
• Disabled during Max / Min function.
• Holding Select button while turning on disables Auto Power-Off
E. Select Functionality Button
• Switch between AC and DC.
• Switch between Ω , , , and .
• Switch between Hz and %.
• Switch between °F and °C.
F. Relative Reading Mode
• Press to store current value.
• Display will now show the difference between the
stored and live readings.
• Press again to return to live reading.
G. Auto / Manual Range
• Press repeatedly to cycle through manual ranges.
• Press for 2 seconds to return to auto ranging mode.
• AT is displayed on LCD only during auto ranging mode.
H. Max / Min Hold
• Press to enter Max / Min mode; the largest and smallest
values will be saved while in this mode.
• Press repeatedly to alternate between the maximum
and minimum readings.
• Press for 2 seconds to return to live reading and
clear the stored maximum and minimum values.
I. Hold / Backlight
• Press to hold the current input on the display.
• Press again to return to live reading.
• Press for 2 seconds to enable / disable lights.
• Using lights drains the battery signifi cantly.
J. K. Battery / Fuse Replacement
• When indicator is displayed on the LCD,
batteries must be replaced.
• Remove rubber boot, back screw, and replace 2 x AAA batteries.
• This meter uses 440mA / 1000V and 11A / 1000V fast blow fuses.
L. Magnetic Hanger Accessory (Optional, Sold Separately)
• Slide magnetic adapter into protective rubber boot.
• Attach instrument to metal for hands-free use.
M. Bar Graph
• The bar graph shows an approximate analog representation
of a measurement.
• The bar graph responds much faster than the digital display.
• The scale of the bar graph is zero to the maximum reading of
the selected range.