BT 1300 Executive User Manual
Page 37
On-Air 1300 Executive user guide ~ Edition 3 ~ 7th August ’01 ~ 3992
36
Press the UP or DOWN button to
select Prefix.
Press OK.
Press OK to select Prefix val.
Enter the switchboard external line
access code, e.g. 9. You can enter
codes up to 8 digits in length.
Press OK to store.
Now you must set the number of digits
required to make internal calls to other
extensions on your switchboard.
Press the UP or DOWN button to
select Min.length.
Press OK.
Enter the number of digits to make an
internal call to other extensions on
your switchboard.
Press OK to store.
C
OK
C
OK
C
OK
C
OK
C
OK
▲
▼
Note
For the external line access code to be dialled
for external calls only, it is important that all
external numbers stored in your handset
directory must contain more digits than the
number of digits required to make an internal
call to other extensions on your switchboard.
This is most likely to occur when you have
local external numbers stored in the handset
directory without the area code. To overcome
potential problems ensure that all numbers
are stored complete with area code.
Press the UP or DOWN button to
select Base.
Press OK.
Press the UP or DOWN button to
select Base settings.
Press OK.
Press the UP or DOWN button to
select Phone Line.
Press OK.
Press the UP or DOWN button to
select Prefix.
Press OK.
Press the UP or DOWN button to
select Status.
Press OK.
Press the
to activate or de-activate.
When active the
✔
will be shown on
the display.
To activate and de-activate the
external line access code
C
OK
C
OK
C
OK
C
OK
C
OK
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼