Braun NVL SERIES - Manual (Page 49)

Page 47
Maintenance and Lubrication Schedule
1500
Cycles
continued
Make sure lift operates smoothly
Inspect external snap rings:
• Handrail pivot pins (2 per pin)
• Platform slide/rotate pivot pins (2 per pin)
• Platform fold axles (1 per axle)
• Inner roll stop lever bracket pins (1 per pin)
• Lift-Tite
™ latch gas (dampening) spring (2 per)
• Outboard platform pivot pins (1 per pin)
• Gear weldment pivot pins (1 per pin)
Inspect platform fold axles and bearings for wear or
damage and positive securement
Inspect platform fold link rollers and bearings for
wear or damage and positive securement
Remove pump module cover and inspect:
‡+\GUDXOLFKRVHVÀWWLQJVDQGFRQQHFWLRQVIRU
wear or leaks
• Harness cables, wires, terminals and connec-
tions for securement or damage
• Control board, circuit breaker, power switch and
lights for securement or damage
Realign towers and vertical arms. Lubri-
cate or correct as needed.
Resecure or replace if needed.
Replace damaged parts and resecure as
needed. Apply Light Oil.
Resecure, replace or correct as needed.
Note: Apply Loctite
® to threads if needed.
Resecure, replace or correct as needed.