Braun NVL SERIES - Manual (Page 50)

Page 48
Maintenance and Lubrication Schedule
Resecure, replace or correct as needed
Use Braun 32840-QT (Exxon ® Univis HVI 26)
K\GUDXOLFÁXLG do not mix with Dextron III or other
K\GUDXOLFÁXLGV &KHFNÁXLGOHYHOZLWKplatform
lowered fully and roll stop unfolded fully. Fill
WRZLWKLQßRIWKHERWWRPRIWKHßÀOOWXEH
(neck).
Tighten, repair or replace if needed.
Replace if needed.
Tighten or replace if needed.
Replace damaged parts and lubricate if needed
Replace if needed.
Inspect cotter pins on platform pivot pin (2)
Hydraulic Fluid (Pump) - Check level. Note: Fluid
should be changed if there is visible contamination.
,QVSHFWWKHK\GUDXOLFV\VWHP F\OLQGHUKRVHVÀW-
WLQJVVHDOVHWF IRUOHDNVLIÁXLGOHYHOLVORZ
,QVSHFWF\OLQGHUVÀWWLQJVDQGK\GUDXOLFFRQQHFWLRQV
for wear, damage or leaks
Inspect parallel arms, bushings and pivot pins for
visible wear or damage
Inspect parallel arm pivot pin mounting bolts (8)
Inspect vertical arms, handrails and pivot pins for
visible wear or damage
Inspect upper/lower fold arms, rotating pivot slide
arms, slide support arms and associated pivot pins,
bushings, and bearings for visible wear or damage
4500
Cycles
Perform all procedures listed in previous section also