Hl-4040cn / hl-4050cdn) – Brother HL 4040CN User Manual
Page 116
Control panel setup
109
10
Changing the print server settings using the control panel
LAN menu
10
Before using your Brother printer in a network environment you need to configure the correct TCP/IP settings.
For more information, see Changing the print server settings on page 15.
In this section, you will learn how to configure the network settings using the control panel, located on top of
the printer.
The LAN menu selections of the control panel allow you to set up the Brother printer for your network
configuration. Press any of the Menu buttons (+, -, OK or Back), and press the + or - button to move forward
or backward through the menus until LAN is displayed. Press the OK button to move to the next menu level.
Press the + or - button to proceed to the menu selection you wish to configure.
Please note that the printer is supplied with the BRAdmin Light utility and Web Based Management (web
browser), which can also be used to configure many aspects of the network. See Changing the print server
settings on page 15.
Control panel LAN menu table and default factory settings
10
(HL-4040CN / HL-4050CDN)
10
See (HL-4070CDW) on page 110 for the HL-4070CDW LAN menu table.
1
On connection to the network, if the printer's 'BOOT Method' is 'Auto' the printer will attempt to automatically set the IP address and Subnet Mask
from a boot server such as DHCP or BOOTP. If a boot server cannot be found, an APIPA IP address will be allocated, such as
169. 254. [001-254]. [000-255]. If the 'BOOT Method' of the printer is set to 'Static' you will need to manually enter an IP address from the printer's
control panel.
Level one
Level two
Level three
Options
LAN
TCP/IP
BOOT Method
Auto
*, Static, RARP, BOOTP, DHCP
IP Address
[000-255].[000-255].[000-255].[000-255]
[000].[000].[000].[000]
Subnet Mask
[000-255].[000-255].[000-255].[000-255]
[000].[000].[000].[000]
Gateway
[000-255].[000-255].[000-255].[000-255]
[000].[000].[000].[000]
*
IP Boot Tries
0
to 32767
3
*
APIPA
On
*, Off
IPv6
On
, Off*
Ethernet
Auto
*, 100B-FD, 100B-HD, 10B-FD, 10B-HD
Factory Reset
OK?
-