Brother HL 4040CN - Manual (Page 57)

Wireless configuration for Windows ® using the Brother automatic installer application
50
4
n
Choose the printer you wish to configure, and click Next. If the list is blank, check if the access point and
the printer are powered on, and then click Refresh.
Note
The default Node name is “BRNxxxxxx” for the users that temporarily connect with a network cable, or
“BRWxxxxxx” for the users that connect without a network cable (where “xxxxxx” are the last six digits of
Ethernet address).
o The wizard will search for wireless networks available from your printer. Choose the access point you
wish to associate the printer with, and then click Next.
Note
• "SETUP" is the default SSID of the printer. Do not choose this SSID.
• If the list is blank, check that the access point has power and is broadcasting the SSID, and then see if the
printer and the access point are within range for wireless communication. Then, click Refresh.