Brother HL 4040CN - Manual (Page 166)

159
A
A
Using services
A
A service is a resource that can be accessed by computers that wish to print to the Brother print server. The
Brother print server provides the following predefined services (do a SHOW SERVICE command in the
Brother print server remote console to see a list of available services): Enter HELP at the command prompt
for a list of supported commands.
Where xxxxxx is the last six digits of the Ethernet address (for example, BRN310107_P1).
Other ways to set the IP address (for advanced users and
administrators)
A
For information on how to configure your network printer using the BRAdmin Light utility or Web Based
Management (web browser), see Setting the IP address and subnet mask on page 12.
Using DHCP to configure the IP address
A
The Dynamic Host Configuration Protocol (DHCP) is one of several automated mechanisms for IP address
allocation. If you have a DHCP server in your network, the print server will automatically obtain its IP address
from the DHCP server and register its name with any RFC 1001 and 1002-compliant dynamic name services.
Note
If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the boot method
to static so that the print server has a static IP address. This will prevent the print server from trying to
obtain an IP address from any of these systems. To change the boot method, use the printer’s control
panel LAN menu, BRAdmin application or Web Based Management (web browser).
Using BOOTP to configure the IP address
A
BOOTP is an alternative to rarp that has the advantage of allowing configuration of the subnet mask and
gateway. In order to use BOOTP to configure the IP address make sure that BOOTP is installed and running
on your host computer (it should appear in the /etc/services file on your host as a real service; type man
bootpd
or refer to your system documentation for information). BOOTP is usually started up via the
Appendix A
A
Service (Example) Definition
BINARY_P1 TCP/IP binary, NetBIOS service
TEXT_P1 TCP/IP text service (adds carriage return after each line feed)
POSTSCRIPT_P1
PostScript ® service (switches PJL-compatible printer to PostScript ® mode)
PCL_P1
PCL ® service (switches PJL-compatible printer to PCL ® mode)
BRNxxxxxx_P1_AT
LPD PostScript
®
service for Mac OS
®
X