Landoll 173531 FRAME STABILIZER KIT - Manual (Page 6)

1-6 Brillion Farm Equipment F-694 Edition
Brillion, Wisconsin 54110 rev10-09-2012
12. Install BRACE-LH SIDE, P/N 173175 on the left hand
side of frame.
a. Remove any zip ties securing the light harness in
the area where the weldment will attach to the
frame.
b. If the machine has a scraper package loosen the
fourth, fifth, sixth, and seventh from the outside
scrapers (do not need to be removed). Slide
them downward to make room to get the
weldment into position.
c. The BRACE-LH SIDE, P/N 173175 must be
positioned from the lower side of the frame
upward into the frame.
d. Secure the front plate of the weldment with ten
(10) 5/8-11 x 6 hex head cap screws. Secure the
hex head cap screws with 5/8-11 hex lock nuts
loosely. Do not tighten these screws at this time.
e. Secure the rear portion of the weldment by
positioning the PLATE-OFFSET REAR MOUNT,
P/N 173533 on the upper surface to the rear
frame tube just above the corresponding plate of
the weldment.
f. Secure the plates with five (5), 5/8-11 x 6 hex
head cap screws (See Figure 1-10). Orient the
screws from the bottom upward. Secure the hex
head cap screws with 5/8-11 hex lock nuts.
g. Secure the light harness as needed.
h. Readjust the scrapers that were loosened.
13. Remove the 1/2 x 6 clevis pin w/ 5/32 hair pin
inserted in the lift linkage described in step 4.
14. Lower the center section of the Wing Float Pulverizer
to the ground. Torque all 5/8-11 hex lock nuts and
hex head cap screws to 110 foot-pounds and all the
1/2-13 hex lock nuts and hex head cap screws to 55
foot-pounds.
15. Check the light harness for proper placement and
that it is properly secured.
16. Check the hydraulic lines for leaks. Check the
hydraulic lines for proper placement out of harm’s
way.
Figure 1-10
photo 5
5/8-11 HEX LOCK NUT
5/8-11 X 6 HEX
HEAD CAP SCREW
PLATE - OFFSET
REAR MOUNT