Landoll WL SERIES TOOTH CONTROL KITS - Manual (Page 21)

9J223
9J223 21
2
4
1
7
3
4
9
9
2
5 2
5
7
3
4
6 8 6 8
2
1
RH WING
LH WING CENTER
FRAME
TIGHTENING PROCEDURE FOR
JIC 37° SWIVEL FEMALE NUTS
1. Check flare and seat for defects.
2. Lubricate the connection.
3. Install hoses without twists.
4. Hand tighten until connection bottoms.
5. Using 2 wrenches to prevent twisting,
rotate the swivel nut 2 wrench flats
(1/3 turn).
6. For reassembly, follow the same
procedure but tighten only 1 wrench
flat (1/6 turn).
TIGHTENING PROCEDURE FOR
SWIVEL O-RING FITTINGS
1. Install the fitting until the metal washer
which backs up the o-ring contacts the
face of the boss.
2. Then orient the fitting by turning
counterclockwise up to 1 turn.
3. Tighten the lock nut using 50-60 foot
pounds torque.
4
WLHydSchematic
WL Pulvimulcher Conversion Kit for Independent Tooth Control
Item Part Number Qty Description Weight
1 3J603 3 HYDRAULIC CYLINDER 50.06
2 4K602 8 ADAPTER,08MJ x 08MOR 0.15
3 4K604 2 CROSS,08MJ 0.37
4 4K608 4 ELBOW,08MJ x 08FJS x 90° 0.27
5 4K912 2 COUPLING,MALE TIP x 08FOR 0.20
6 4K881 2 HOSE ASM,3/8 x 29”,3/4-16 SWIVEL FEMALE JIC 37° 0.56
7 4K619 2 HOSE ASM,3/8 x 134”,3/4-16 SWIVEL FEMALE JIC 37° 2.90
8 4K615 2 HOSE ASM,3/8 x 196”,3/4-16 SWIVEL FEMALE JIC 37° 3.65
9 5K597 2 HOSE ASM,3/8 x 252”,3/4-16 SWIVEL FEMALE JIC 37° 4.83
WLHydSchematic
10-31-07 Page 19