Landoll M-1241 TRANSPORT PULVI-MULCHER - Manual (Page 24)

LED Lamp and Harness Installation
1. Attach the 4 (four) Light Brackets to the frame using 4 Straps and 8 (eight) ½ x
3.75 HHCS, Washers and Nuts.
2. Install the Amber LED's inside the Light Shields in the outside brackets. Ensure 2
prong cord sticks out the light shield slot opening.
3. Install the Red LED’s inside the Light Shields in the inner brackets. Ensure 3
prong cord sticks out the light shield slot opening.
3. Attach the Light Module under the Light Module Weldment located on the front of
the rear frame tube, using 1/4-20 X 1-1/2 Screws and Locknuts.
4. Route the flat end of the 7 pin harness through the Hose Support and along the
Center Frame. Attach to the Light Module. Route the other end along the drawbar with
the hydraulic hoses up to the hitch point.
Cords are marked Left ( ) and Right ( ).
5. Layout the LED Lamp Harness. Note that the cords are marked left (Yellow Tape)
and right (Green Tape). Attach the harness to the Light Module.
6. Route the 2 prong cords along the left and right front of the rear frame tube and
attach to Amber LED's.
7. Route the 3 prong cords similar, attach to the Red LED's.
8. Secure both harnesses with tie straps, making sure to leave enough slack, where
the drawbar meets the frame, to allow the machine raise and lower. Secure LED lamp
harness molded union to the top of the inner frame tube using Tie Straps. Bundle and
secure any excess cord with tie straps.
9. Raise, lower, fold and unfold machine to check for proper clearance, adjust
accordingly.
All cords must be firmly attached to the machine frame members, or hydraulic lines, so
they don't sag or become torn loose by field debris. Use the cable and hoses ties
provided.
10. Attach the SMV sign to the SMV Mount using two 5/16-18 X 1 Screws, Washers,
Yellow Tape Green Tape
1092rev0414 Page 19B 2K793