Landoll XXLO184 X-Fold Pulverizer - Manual (Page 15)

190rev501 9J698 Page 10A
OPTIMIZER WHEEL PLACEMENT
38’ - 46’ Wide Models with
20” Optimizer Wheels - 4 ” bore (6K351 Wheel & 6K352 End Wheel)
CENTER SECTION
(2x)13 Wheels, (2x)2 End Wheels)
NOTE:
Wheel Gangs on the XXL model Optimizer wings are not identical -
on some the pipe shaft extends farther out beyond the wheels. Place these on the outside end of the machine. The above diagram shows wheel gang positioning and assembly for the center and wings of optimizer model pulverizers using
optimizer
wheels.
When assembling, position the axle clamps toward the outside end of the wing and the machine.
Also,
it is especially import
ant that fit of wheels
on the shaft remains tight.
Wear and damage can result from wheels
that do not fit tightly against one another
. Make frequent checks to insure
that close fit remains intact. If wheels have jostled apart, adjustment is made by loosening and moving the clamp until the wheels are tightly in place. Then retighten clamp.
Position
All
Axle Clamp
s to ends
opposite Center Bearing
Center Brkt & Brng
6K351 Optimizer Wheel
“XXLO” Models
Male & female hub ends must
mate and
remain in
close contact.
11
’ Wing - 140 1/2
12’ Wing - 152 1/2”
13’ Wing - 164 1/2”
14’ Wing - 176 1/2”
15’ Wing - 188 1/2”
183 13/16”
90 3/4”
Center Brkt & Brng
6K506=10 Wheels + 6K505=12 Wheels 6K509=12 Wheels + 6K505=12 Wheels
w/ Longer Pipe
6K510=14 Wheels
+
6K505=12 Wheels
6K510=14 Wheels
+
6K505=14 Wheels
6K504=15 Wheels
+
6K504=15 Wheels
w/ Longer Pipe
6K505=12 Wheels + 6K506=10 Wheels
Place wheel gang that has pipe which extends beyond wheels to the outside end of the machine.