Landoll 9650 Field Cultivator - Manual (Page 65)

ASSEMBLY INSTRUCTIONS
3-25
Rear Tow Hitch (Option)
1. Lower the field cultivator to the ground and place
supports under the front frame bar.
2. Remove the front-to-rear leveling tube (See
Figure 3-18.)
3. Remove the cylinder pins from the rear fold cylinder
mount.
4. Remove the rear fold cylinder mount from the rear
frame bar.
5. Slide the rear tow into place over the top of the field
cultivator frame, and attach the rear tow hitch
assembly to the rear bar of the cultivator. Leave the
u-bolts loose until all other bolts have been installed.
6. Attach the front of the tow hitch assembly to the
cultivator frame cross tubes using u-bolts and
locknuts.
7. Reinstall the rear cylinder fold mount and re-pin the
rear fold cylinders.
8. Reinstall the front-to-rear leveling tube.
9. Route the rear tow hitch wiring harness connector
across the rear frame bar to the right rear tail light.
Unplug the existing four-pin wiring harness from the
lighting module. Connect the rear tow hitch harness
between the lighting module and the filed cultivator
wiring harness.
10. Route the rear tow hitch hydraulic hoses along with
the other hydraulic hoses along the right side of the
center frame to the front of the hitch.
11. Secure the hoses & wiring to the frame using
tie-straps and hose clamps.