Landoll 2111 Coulter Chisel - Manual (Page 33)

3-1
Chapter 3
Assembly Instructions
It is very important that your new 2111 Coulter Chisel be
properly assembled, adjusted and lubricated before use.
Illustrations to assist with the assembly process are
provided in “Standard Specifications” on page 2-1.
They show proper shank and light mounting bracket
spacing. Illustrations in this section show proper
assembly procedures. Remove paint from grease fittings.
Replace any grease fittings that are damaged or missing.
Be sure to return screws, clips, etc., to their original
locations.
To insure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
(See Table 2-1 and Table 2-2).

DANGER

WARNING

DANGER

CAUTION

CAUTION
Coulter blades are extremely sharp. Exercise
extreme care when working on or near coulter
blades. Do not allow coulters to roll over or fall
onto any body part. Do not allow wrenches to slip
when working near coulter blades. Never push
wrenches toward coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges can cause
serious personal injury or death.
Do not attempt to lift heavy parts (such as the
frame, coulter gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.
Incorrect adjustment of disc adjust rods will
cause permanent equipment damage.