Landoll 2000 Series Row Crop Cultivator - Manual (Page 34)

4-8 F-140-0512 Edition
OPERATION AND MAINTENANCE
Tool Frame
1. The length of up and down movement for the tool
frame is controlled by the limit chain (See Figure
4-6) on the left side of the tool frame. If a different
distance of movement is required, change the limit
chain one link at a time until the desired amount of
movement is met.
IMPORTANT
A longer limit chain setting will result in less ground
clearance when the machine is lifted out of the
ground.
Ridgers and Knives
1. Adjust the ridgers or anhydrous ammonia knives
(See Figure 4-7) by loosening the clamp bracket on
the shank, and slide the ridger or knife to the desired
depth. Loosen the ridger bracket bolts and slide the
ridgers in or out to the desired width. Retighten the
bracket bolts.
Figure 4-6: Limit Chain Adjustment
Figure 4-7: Ridger and Knife Adjustment
3/4-10 U-BOLT
LIMIT CHAIN
7/16-14 HEX
LOCK NUT
7/16-14 X 2 HEX
HEAD CAP SCREW
2ma410-010905
545ma104602 op
SHANK
U-BOLT
SHANK
ANHYDROUS AMMONIA
KNIFE (OPTION)
LEFT HAND SIDE
5/8-11 HEX
LOCK NUT
RIDGER (OPTION)
RIGHT HAND
SIDE